EXOv5 Ultra Durable Hydrophobic Coating - 50ml

EXOv5 is a hydrophobic coating that creates a protective layer on your car’s paint, delivering extreme water beading and lasting protection for up to two years. This ceramic coating produces a high-gloss, warm-looking finish while offering resistance to water spots, road grime, dust, and wash chemicals.

Unlike car wax or standard sealants that break down quickly, EXOv5 forms a hard film with anti-static properties that repel dirt particles, reducing the need for frequent cleaning. The formula withstands UV rays, road salt, and environmental contaminants that can corrode surfaces over longer periods. Application is easy with a slow flash-off time, giving you more time to achieve a perfect finish without the pressure of professional application.

EXOv5 can be applied as a standalone coating or as a top layer over Crystal Serum Light or C1 Crystal Lacquer for enhanced durability and swirl mark resistance on easy-to-mark and dark paints.

Features:

• Single-layer application
• 18-24 months durability
• Easy to apply
• Adds gloss, water and dirt repellency

Simple Steps To Help You Get The Best Results:

• EXOv5 can be applied as a standalone sealant or as a top layer for C1 Crystal Lacquer, Crystal Serum Ultra, or Crystal Serum Light (CSL)
• If applying over C1, apply EXOv5 a minimum of 4 hours, but less than 12 hours, after finishing the C1 application
• If applying over CSL, EXOv5 can be applied straight away starting at the same place you did with CSL; for best results, wait two hours to let the product flash off longer
• Ensure the vehicle is out of direct sunlight but warmer than 5 degrees Celsius (41°F, completely dry, and will stay dry for at least 12 hours after application
• Wipe down all surfaces using Panel Wipe and an MF1 ZeroR Microfibre Buff Cloth (apply to the cloth, not the panel); skip this step if applying over newly applied C1 or CSL
• Shake the bottle well and wear gloves
• Prime the AP2 Ultra Soft Foam Filled Applicator evenly with product so the pad is damp
• Apply in overlapping strokes to a small panel or half a large panel
• Immediately remove residue with an MF1 cloth; buff the same area several times without too much force, then follow with a second MF1 to remove any smearing
• Allow the coating to cure for at least 12 hours before getting wet
• Do not wash the car for at least a week after application
• Store in a cool, dry place and use within 3 months of opening